Make Bot MightyBoard RevE
From Geeetech Wiki
Revision as of 07:12, 21 August 2014 by Admin (talk | contribs) (Created page with "==Introduction== This is the MakerBot MightyBoard, a revolution in 3D Printer Control Technology. Use it to power your MakerBot Replicator 3D Printer. Here are just a few thin...")
Introduction
This is the MakerBot MightyBoard, a revolution in 3D Printer Control Technology. Use it to power your MakerBot Replicator 3D Printer. Here are just a few things the MightyBoard can do: control up to 5 stepper motors with BotStep Stepper Controllers, control up to two extruders (with heater cartridges, safety thermostats, thermocouples, and fans), control the Replicator Interface Board, connect to up to 6 endstops, control RGB LED light strips, control a heated build platform, and much much more!
Features
- Pizeo Buzzer
- Lots of Debugging LEDs and extra I/O pins broken out for hacking
- Access to I2C and UART for hacking
- Hardware-based safety cutoff for extruders
- Extra FET for hacking
- Arduino Mega Compatible
- digitally-controlled potentiometers for setting motor currents (no more trimpots!)
