Breakout Board for microSD Transflash

From Geeetech Wiki
Revision as of 05:43, 31 January 2013 by Admin (talk | contribs)

Jump to: navigation, search

Introduction

Breakout board for the microSD socket that is not much bigger than your fingernail.

Compatible with the SPI interface found on any SD card, this tiny form factor was created for cell phone storage and is perfect for your next MP3 project!

Board comes fully assembled and tested.The bare socket is available.


Features

  • SPI mode
  • Support voltage:3.0 to 3.6V
  • Up to 50 MB/sec data transfer rate
  • Sits directly on a Arduino
  • Also be used with other microcontrollers