Geeetech Mizar S 3D Printer

From Geeetech Wiki
Revision as of 06:33, 4 January 2023 by Admin (talk | contribs) (How to replace a hotend)

Jump to: navigation, search

Introduction

Product details

Unpacking and proper handling

Slicing

Printer maintenance

How to replace a hotend

Tools necessary for this guide
Wrench size 10 mm

Allen keys – 1.5/2/2.5/3 mm

Flat screwdriver tip width 2.5 mm

Diagonal pliers

Electrical tape

Zip ties

Craft knife or equivalent


Step 1 Preparing


Mizars002.png Preheat the nozzle to 220 Celsius from the LCD menu, then unload the filament from the hotend.

Mizars019.png Remove the Teflon tube from the hotend.


Before moving to step 2, remember to turn the printer off and unplug it from the socket!


Step 2 Disassembling the hotend


Mizars008.png Remove the hotend housing and disconnect the hotend thermistor.


Mizars009.png Release and remove the two screws that secure the hotend, then unplug all the cables on the extension board.


Mizars010.png

Mizars011.png Remove the extension board and the part cooling fan.

Mizars012.png Remove the strain gauge.


Step 3 Disconnecting the hotend cables

Mizars013.png Remove the bottom cover and disconnect the cooling fan.


Mizars014.png Disconnect the heater cartridge.


Mizars016.png Cut off the heat-shrink tubing from the connection wire. Avoid cutting the cable.


Mizars018.png Remove the old heater cartridge.

How to clean the hotend and replace a nozzle

Tools necessary for this guide
Tweezers for nozzle

Wrench size 6/10/20 mm

Cleaner rod (1.5mm diameter, 100mm length)

Needle for nozzle

Allen key - 2 mm

How to replace a control board

Tools necessary for this guide
Allen keys – 2.5/3 mm

Flat screwdriver tip width 2.5 mm

How to replace PSU

Tools necessary for this guide
Allen keys - 2.5/3 mm

Philips screwdriver for PSU cables

How to replace a hotbed

Tools necessary for this guide
Allen keys – 3 mm

Flat screwdriver tip width 2.5 mm

Diagonal pilers

Zip ties

How to replace a screen

Tools necessary for this guide
Allen keys - 2.5/3 mm