Asssembly

From Geeetech Wiki
Revision as of 02:26, 14 November 2013 by Admin (talk | contribs)

Jump to: navigation, search

1. Check that you have everything that's needed

2.png

2. Twist the two motor wires together so they are easier to handle (and electromagnetic noise is reduced)

3.png 4.png

3. Thread the twisted motor wires through the motor mount arm section. It can be a bit tricky so have patience.

5.png 6.png 7.png

4. Insert the motor into the motor mount and be careful to not damage the motor wires while inserting it.

8.png

5. Press the motor mount on to the PCB arm. Be careful not to damage the wires when you do it. Start with M1.

10.png

6. Try to attach the peeled end of the motor wire into the motor through hole pad. Start with white wire on round pad on M1

9.png 12.png

7. Turn the PCB around carefully not removing the wire from the hole and solder it from the top of the PCB. The square pads can take a bit longer to heat up as they are connected to the battery supply copper plane.

13.png 14.png

15.png200px17.png

alt text
alt text
alt text
alt text
alt text
File:File.png
alt text
File:File.png
alt text