Serial I2C 1602 16×2 Character LCD Module

From Geeetech Wiki
Revision as of 03:17, 2 June 2012 by Admin (talk | contribs) (Contrast adjust)

Jump to: navigation, search

Introduction

1602I2C 1.jpg 1602I2C 2.jpg

This is another great blue/yellow backlight LCD display. As the pin resources of Arduino controller is limited, your project may be not able to use normal LCD shield after connected with a certain quantity of sensors or SD card. However, with this I2C interface LCD module, you will be able to realize data display via only 2 wires. If you already has I2C devices in your project, this LCD module actually cost no more resources at all. It is fantastic for Arduino based project.

Features

  • Interface: I2C
  • I2C Address: 0x27
  • Pin Definition : VCC、GND、SDA、SCL
  • Back lit (Green with white char color)
  • Supply voltage: 5V
  • Size : 27.7mm×42.6mm
  • Contrast Adjust : Through Potentiometer
  • Only employ two I/O interface

Connection diagram

Here is pic shows how to connect an Arduino 1602 I2C module.The following is a table describing which pins on the Arduino should be connected to 1602 I2C LCD module.

1602I2C 4.jpg

1602I2C table.jpg

Contrast adjust

1602I2C 3.jpg

Spin the potentimeter clockwise to increase contrast ,spin unclockwise to decrease it

Example code

Download Arduino 1602 I2C library

#include <Wire.h> 
#include <LiquidCrystal_I2C.h>
LiquidCrystal_I2C lcd(0x27,16,2);  // set the LCD address to 0x27 for a 16 chars and 2 line display
void setup()
{
 lcd.init();                      // initialize the lcd 
 // Print a message to the LCD.
 lcd.backlight();
 lcd.print("Hello, world!");
}
void loop()
{
}

How to buy

Click here to buy Arduino Serial I2C 1602 16×2 Character LCD Module