Difference between revisions of "Breakout Board for microSD Transflash"
From Geeetech Wiki
(Created page with " == Introduction == Breakout board for the microSD socket that is not much bigger than your fingernail. Compatible with the SPI interface found on any SD card, this tin...") |
|||
| Line 10: | Line 10: | ||
Compatible with the SPI interface found on any SD card, this tiny form factor was created for cell phone storage and is perfect for your next MP3 project! | Compatible with the SPI interface found on any SD card, this tiny form factor was created for cell phone storage and is perfect for your next MP3 project! | ||
| − | + | Board comes fully assembled and tested.The bare socket is available. | |
Revision as of 05:43, 31 January 2013
Introduction
Breakout board for the microSD socket that is not much bigger than your fingernail.
Compatible with the SPI interface found on any SD card, this tiny form factor was created for cell phone storage and is perfect for your next MP3 project!
Board comes fully assembled and tested.The bare socket is available.
Features
- SPI mode
- Support voltage:3.0 to 3.6V
- Up to 50 MB/sec data transfer rate
- Sits directly on a Arduino
- Also be used with other microcontrollers
