Difference between revisions of "Sound Sensor"

Revision as of 02:53, 17 September 2012

Overview

The Sound sensor module is a simple microphone based on a opamp LM358 to amplify the sound strength of the environment like door knocks, etc loud enough to be picked up by a microcontroller's Analog to Digital converter. The value of output can be adjusted by the potentiometer.

Applications

• Simple microphone
• Sound detection

Connection Diagram

Here is the guide illustrates how to connect an Arduino to the sound sensor. The following is a table describing which pins on the Arduino should be connected to the pins on the sound sensor:

VCC <-------> VCC
GND <-------> GND
 S  <-------> Analog 0

Examples

void setup()
{
 Serial.begin(9600); // open serial port, set the baud rate to 9600 bps
}
void loop()
{
     int val;
     val=analogRead(0);   //connect mic sensor to Analog 0
     Serial.println(val,DEC);//print the sound value to serial       
     delay(100);
}

How to buy

Click here to buy Sound sensor