Difference between revisions of "Opto-isolator Breakout"

From Geeetech Wiki
Jump to: navigation, search
(introduction)
Line 1: Line 1:
 
==introduction==
 
==introduction==
[[File:Opto-isolator Breakout09118.jpg]]
+
[[File:Opto-isolator Breakout09118.jpg|300]]
  
 
This is a board designed for opto-isolation. This board is helpful for connecting digital systems (like a 5V microcontroller) to a high-voltage or noisy system.  
 
This is a board designed for opto-isolation. This board is helpful for connecting digital systems (like a 5V microcontroller) to a high-voltage or noisy system.  
Line 7: Line 7:
  
 
This allows the low-voltage side to control a high voltage side.
 
This allows the low-voltage side to control a high voltage side.
 
  
 
==Features==
 
==Features==

Revision as of 06:56, 19 January 2013

introduction

300

This is a board designed for opto-isolation. This board is helpful for connecting digital systems (like a 5V microcontroller) to a high-voltage or noisy system.

This board electrically isolates a controller from the high-power system by use of an opto-isolator IC. This IC has two LEDs and two photodiodes built-in.

This allows the low-voltage side to control a high voltage side.

Features

  • Two channel coupler
  • SOIC-8 surface mountable package
  • Standard lead spacing of 0.05"
  • Available only on tape and reel option(conforms to EIA standard 481-2)
  • Isolation test voltage, 4000 VRMS
  • Compatible with dual wave, vapor phase andIR reflow soldering
  • Lead (Pb)-free component
  • Component in accordance to RoHS 2002/95/EC andWEEE 2002/96/EC