Difference between revisions of "Sound Sensor"
From Geeetech Wiki
(→Connection Diagram) |
(→Connection Diagram) |
||
Line 11: | Line 11: | ||
[[File:BT.jpg]] | [[File:BT.jpg]] | ||
− | VCC ------- VCC | + | VCC <-------> VCC |
− | GND ------- GND | + | GND <-------> GND |
− | S ----- Analog 0 | + | S <-------> Analog 0 |
==Examples== | ==Examples== |
Revision as of 02:51, 17 September 2012
Overview
The Sound sensor module is a simple microphone based on a opamp LM358 to amplify the sound strength of the environment like door knocks, etc loud enough to be picked up by a microcontroller's Analog to Digital converter. The value of output can be adjusted by the potentiometer.
Applications
- Simple microphone
- Sound detection
Connection Diagram
VCC <-------> VCC GND <-------> GND S <-------> Analog 0
Examples
void setup() { Serial.begin(9600); // open serial port, set the baud rate to 9600 bps } void loop() { int val; val=analogRead(0); //connect mic sensor to Analog 0 Serial.println(val,DEC);//print the sound value to serial delay(100); }
How to buy
Click here to buy Sound sensor