Difference between revisions of "433Mhz RF link kit"
From Geeetech Wiki
(→Introduction) |
(→How to buy) |
||
(7 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
== Introduction == | == Introduction == | ||
+ | |||
The kit is consisted of transmitter and receiver, popular used for remote control. | The kit is consisted of transmitter and receiver, popular used for remote control. | ||
+ | |||
[[File:Rf1.jpg|600px]] | [[File:Rf1.jpg|600px]] | ||
Line 12: | Line 14: | ||
== Wiring diagram == | == Wiring diagram == | ||
+ | [[File:Wiring111.jpg]] | ||
− | + | ==examlple code== | |
− | = examlple code = | ||
Transmmiter: | Transmmiter: | ||
Line 76: | Line 78: | ||
} | } | ||
} | } | ||
+ | |||
+ | ==How to buy== | ||
+ | Click here to buy [http://www.geeetech.com/433mhz-rf-link-kit-p-160.html 433Mhz RF link kit] |
Latest revision as of 03:19, 29 May 2012
Introduction
The kit is consisted of transmitter and receiver, popular used for remote control.
Specification
- Frequency: 433Mhz.
- Modulation: ASK
- Receiver Data Output: High - 1/2 Vcc, Low - 0.7v
- Transmitter Input Voltage: 3-12V (high voltage = more transmitting power)
Wiring diagram
examlple code
Transmmiter:
#include <VirtualWire.h> #undef int #undef abs #undef double #undef float #undef round void setup() { Serial.begin(9600); // Debugging only Serial.println("setup"); // Initialise the IO and ISR vw_set_ptt_inverted(true); // Required for DR3100 vw_setup(2000); // Bits per sec } void loop() { const char *msg = "hello"; digitalWrite(13, true); // Flash a light to show transmitting vw_send((uint8_t *)msg, strlen(msg)); vw_wait_tx(); // Wait until the whole message is gone digitalWrite(13, false); delay(200); }
Receiver:
#include <VirtualWire.h> #undef int #undef abs #undef double #undef float #undef round void setup() { Serial.begin(9600); // Debugging only Serial.println("setup"); // Initialise the IO and ISR vw_set_ptt_inverted(true); // Required for DR3100 vw_setup(2000); // Bits per sec vw_rx_start(); // Start the receiver PLL running } void loop() { uint8_t buf[VW_MAX_MESSAGE_LEN]; uint8_t buflen = VW_MAX_MESSAGE_LEN; if (vw_get_message(buf, &buflen))//Non-blocking { int i; digitalWrite(12, true); //Flash a light to show received good message Serial.print("Got: "); //Message with a good checksum received, dump it. for (i = 0; i < buflen; i++) { Serial.print(buf[i], HEX); Serial.print(" "); } Serial.println(""); digitalWrite(12, false); } }
How to buy
Click here to buy 433Mhz RF link kit