|
|
| (3 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| | [[File:dual extruder.jpg]|500px|] | | [[File:dual extruder.jpg]|500px|] |
| − |
| |
| − | =Copyright Declaration=
| |
| − |
| |
| − | The copyright of this manual belongs to the Shenzhen GETECH CO., LTD. (hereinafter referred to as the "Geeetech"), and all rights reserved. No part of this specification should be reproduced or extracted in any forms or means without the prior written consent of Geeetech by any company and individuals.
| |
| − |
| |
| − | =Technical Support=
| |
| − |
| |
| − | If you are interested in the technology of 3 D printing, flight control and U-home, welcome to Geeetech, we have series of made-up products, main boards, modules and a variety of peripherals for you. Or if you are looking for relevant information or technical support, please login our Forum where you can find anything you want about open source. To know more about our new products, please visit www.geeetech.com, we will serve you wholeheartedly.
| |
| − |
| |
| − | =SAFTY INSTRUCTIONS=
| |
| − |
| |
| − | Building the printer will require a certain amount of physical dexterity, common sense and a thorough understanding of what you are doing. We have provided detailed instructions to help you assemble it easily, please download at geeetech.com.
| |
| − |
| |
| − | However ultimately we cannot be responsible for your health and safety whilst building or operating the printer, with that in mind be sure you are confident with what you are doing prior to commencing with building or buying. Read the entire manual to enable you to make an informed decision.
| |
| − |
| |
| − | Building and operating involves electricity, so all necessary precautions should be taken and adhered to, the printer runs on 12V supplied by a certified power supply, so you shouldn’t ever have to get involved with anything over 12V but bear in mind there can still be high currents involved and even at 12V they shouldn’t be taken lightly.
| |
| − |
| |
| − | High temperatures are involved with 3D Printing, the Extrusion nozzle of the hot end can run about 230°C, the heated bed runs 110°C and the molten plastic extruded will initially be at around 200°C, so special care and attention should be made when handling these parts of the printer during operation.
| |
| − |
| |
| − | We wouldn’t recommend leaving your printer running unattended, or at least until you are confident to do so. We cannot be held responsible for any loss, damage, threat, hurt or other negligent result from either building or using the printer.
| |
| − |
| |
| − | =Introduction: =
| |
| − |
| |
| − | Delta Rostock mini G2s succeeds the advantages of the previous version on the respect of steady structure, small physical footprint, simple but really rigid frame, high positioning accuracy, flexible effectors, and very similar specification, and we add some innovative design, such as dual extruders, the brand new control system, the use of Rod-End joint Bearings and metal diagonal rods, on-built LCD control panel and support for multiple filament type.
| |
