Difference between revisions of "Si4703 FM Tuner"
(→How to buy) |
|||
| (14 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | == | + | == Introduction == |
| − | [[File:Si4703.jpg]] | + | [[File:Si4703.jpg|300px]] |
| − | |||
| − | + | This is an evaluation board for the Silicon Laboratories Si4703 FM tuner chip. Beyond being a simple FM radio, the Si4703 is also capable of detecting and processing both Radio Data Service (RDS) and Radio Broadcast Data Service (RBDS) information. The Si4703 even does a very good job of filtering and carrier detection.It also enables data such as the station ID and song name to be displayed to the user. | |
| − | + | Using this board we are able to pick up multiple stations just as well as with a standard FM radio. The board breaks out all major pins and makes it easy to incorporate this great chip into your next radio project. Also, by plugging headphones into the 3.5mm audio jack, you effectively use the cable in your headphones as an antenna! Therefore, this board does not require an external antenna if using headphones or a 3.5mm audio cable longer than 3 feet. | |
== Features == | == Features == | ||
* 2.7 to 5.5 V supply voltage | * 2.7 to 5.5 V supply voltage | ||
| − | |||
* Worldwide FM band support (76–108 MHz) | * Worldwide FM band support (76–108 MHz) | ||
* Digital low-IF receiver | * Digital low-IF receiver | ||
| + | * Volume control | ||
| + | * Seek tuning | ||
| + | * Signal strength measurement | ||
| + | |||
| + | == Usage == | ||
| + | [[File:Si4703 diagram.jpg|450px]] | ||
| + | |||
| + | connect the following 5 wires: | ||
| + | Arduino : Si470x board | ||
| + | 3.3V : VCC | ||
| + | GND : GND | ||
| + | A5 : SCLK | ||
| + | A4 : SDIO | ||
| + | D2 : RST | ||
| + | |||
| + | == example code == | ||
| + | [http://www.geeetech.com/Documents/Si4703_Example.pde Si4703_Example] | ||
| + | |||
| + | == Document == | ||
| + | [http://www.geeetech.com/Documents/Si4703%20datasheet.pdf Si4703 datasheet] | ||
| + | |||
| + | == How to buy == | ||
| + | Click here to buy [http://www.geeetech.com/silicon-laboratories-si4703-fm-tuner-evaluation-board-p-621.html Si4703 FM Tuner Evaluation Board] | ||
Latest revision as of 06:17, 26 December 2014
Introduction
This is an evaluation board for the Silicon Laboratories Si4703 FM tuner chip. Beyond being a simple FM radio, the Si4703 is also capable of detecting and processing both Radio Data Service (RDS) and Radio Broadcast Data Service (RBDS) information. The Si4703 even does a very good job of filtering and carrier detection.It also enables data such as the station ID and song name to be displayed to the user.
Using this board we are able to pick up multiple stations just as well as with a standard FM radio. The board breaks out all major pins and makes it easy to incorporate this great chip into your next radio project. Also, by plugging headphones into the 3.5mm audio jack, you effectively use the cable in your headphones as an antenna! Therefore, this board does not require an external antenna if using headphones or a 3.5mm audio cable longer than 3 feet.
Features
- 2.7 to 5.5 V supply voltage
- Worldwide FM band support (76–108 MHz)
- Digital low-IF receiver
- Volume control
- Seek tuning
- Signal strength measurement
Usage
connect the following 5 wires: Arduino : Si470x board 3.3V : VCC GND : GND A5 : SCLK A4 : SDIO D2 : RST
example code
Document
How to buy
Click here to buy Si4703 FM Tuner Evaluation Board
