Difference between revisions of "Geeetech Mizar S 3D Printer"
From Geeetech Wiki
(→How to replace a hotend and a nozzle) |
(→How to replace a control board) |
||
| Line 56: | Line 56: | ||
=== '''How to replace a control board'''=== | === '''How to replace a control board'''=== | ||
| + | |||
| + | {| class="wikitable" | ||
| + | |- | ||
| + | ! Tools necessary for this guide | ||
| + | |- | ||
| + | | Allen keys – 2.5/3 mm | ||
| + | |||
| + | Flat screwdriver tip width 2.5 mm | ||
| + | |||
| + | |} | ||
=== '''How to replace PSU'''=== | === '''How to replace PSU'''=== | ||
Revision as of 02:34, 4 January 2023
Contents
Introduction
Product details
Unpacking and proper handling
Slicing
Printer maintenance
How to replace a hotend
| Tools necessary for this guide |
|---|
| Wrench size 10 mm
Allen keys – 1.5/2/2.5/3 mm Flat screwdriver tip width 2.5 mm Diagonal pliers Electrical tape Zip ties Craft knife or equivalent |
How to clean the hotend and replace a nozzle
| Tools necessary for this guide |
|---|
| Tweezers for nozzle
Wrench size 6/10/20 mm Cleaner rod (1.5mm diameter, 100mm length) Needle for nozzle Allen key - 2 mm |
How to replace a control board
| Tools necessary for this guide |
|---|
| Allen keys – 2.5/3 mm
Flat screwdriver tip width 2.5 mm |
