Difference between revisions of "Methane Gas Sensor - MQ-4"

From Geeetech Wiki
Jump to: navigation, search
(Created page with "==Introduction== File:MQ-2 1.jpg MQ-4 gas sensor modules are used in gas leakage detecting equipments in family and industry, are suitable for detecting of CH4,Natura...")
 
(How to buy it)
 
(3 intermediate revisions by the same user not shown)
Line 14: Line 14:
  
 
==Specification==
 
==Specification==
[[File:MQ-2 0.jpg|200px]]
+
[http://www.geeetech.com/Documents/MQ-4%20Datasheet.pdf MQ-4 datasheet]
 
 
Detection range: 300 to 10000ppmm<br>
 
The characteristics gas: 1000ppmm, isobutane<br>
 
Sensitivity: R in air / Rin, typical gas ≥ 5<br>
 
Sensing Resistance: 1KΩ 50ppm toluene to 20KΩ in.<br>
 
Response time: ≤ 10s<br>
 
Recovery time: ≤ 30s<br>
 
Heat resistance: 31Ω ± 3Ω<br>
 
Heating current: ≤ 180mA<br>
 
Heating voltage: 5.0V ± 0.2V<br>
 
Heating power: ≤ 900mW<br>
 
Measuring voltage: ≤ 24V<br>
 
Working conditions of ambient temperature: -20 ℃ ~ +55 ℃<br>
 
Humidity: ≤ 95% RH<br>
 
Environmental oxygen content: 21%<br>
 
Storage conditions Temperature: -20 ° C to +70 ° C<br>
 
Humidity: ≤ 70% RH<br>
 
 
 
==Document==
 
[MQ-2 datasheet]
 
  
 
==Usage==
 
==Usage==
[[File:MQ-usage.jpg]]
+
[[File:MQ-4 pic.jpg]]
  
 
[[File:MO-2 2.jpg]]
 
[[File:MO-2 2.jpg]]
Line 59: Line 39:
  
 
==How to buy it==
 
==How to buy it==
Click here to buy [Gas Sensor - MQ-2]
+
Click here to buy [http://www.geeetech.com/methane-gas-sensor-mq4-p-193.html Gas Sensor - MQ-4]

Latest revision as of 07:17, 10 May 2012

Introduction

MQ-2 1.jpg

MQ-4 gas sensor modules are used in gas leakage detecting equipments in family and industry, are suitable for detecting of CH4,Natural gas.LNG, avoid the noise of alcohol and cooking fumes and cigarette smoke.

Features

  • High sensitivity to CH4,Natural gas
  • Small sensitivity to alcohol, smoke
  • Fast response
  • Stable and long life
  • Simple drive circuit

Specification

MQ-4 datasheet

Usage

MQ-4 pic.jpg

MO-2 2.jpg

VCC - 5V
GND - GND
S   - Analog pin0

Example code

int sensorValue;
void setup()
{
 Serial.begin(9600);      // sets the serial port to 9600
}
void loop()
{
 sensorValue = analogRead(0);       // read analog input pin 0
 Serial.println(sensorValue, DEC);  // prints the value read
 delay(100);                        // wait 100ms for next reading
}

How to buy it

Click here to buy Gas Sensor - MQ-4