View source for Arduino Digital Vibration Sensor module

==introduction==
[[File:Vibration sensor.jpg]]

The Arduino vibration sensor module is based on vibration switch component which can detect the weak vibration signals. The sensor can work for vibration-related modules.

==Product Performance: ==
The conductive pin will make an instant turn-on (ON) state when touched by the outside force to achieve the proper vibration force, or an appropriate speed from the (partial) energy. 
No direction, any angle may burst. 
The switch is suitable for small-current circuit (secondary circuit) or (IC) of the trigger. 
At room temperature and normal use the next switch service life is up to 10 million times (times/1sec).

==Specification==
On-Time: 0.1ms 
Open circuit resistance: 10Mohm

==Usage==
[[File:Vibration wiring.jpg|500px]]

 VCC - 5V
 GND - GND
 S   - Digital pin3


==Example code==
 int ledPin = 13;                // Connect LED to pin 13 
 int switcher = 3;                 // Connect Tilt sensor to Pin3 
  void setup() 
 { 
  pinMode(ledPin, OUTPUT);      // Set digital pin 13 to output mode 
  pinMode(switcher, INPUT);       // Set digital pin 3 to input mode 
 } 
 void loop() 
 { 
      
   if(digitalRead(switcher)==HIGH) //Read sensor value 
     {  
        digitalWrite(ledPin, HIGH);   // Turn on LED when the sensor is tilted
        delay(300);
     } 
   else
     { 
        digitalWrite(ledPin, LOW);    // Turn off LED when the sensor is not triggered 
     } 
 }
==How to buy it==
Click here to buy [vibration sensor]