A30T 3D Touch PRO

[sergiyn]

I'm having problems setting up auto-leveling on my brand new A30T printer.

Bought and installed the 3Dtouch V3.2 pro sensor. Everything seems to work fine, sensor deployment, alarm reset etc. If I try to perform automatic leveling the printer goes into a home position and tries to deploy the sensor not even over the heatbed - always resulting in an error...

I thought it was supposed to go to the center first and then start...

Any ideas/help would be highly appreciated - flashed and tried several firmware options, so there should be no issue with that...

Thanks in advance