I just installed this firmware update for my A10m as from the geeetech page :
https://www.geeetech.com/download.html?download_id=31
A10M_TITANS_HW4.1B_FW2.3_20201021-Beta.hex
The hot-end will not heat up. The bed does but then heating fails.
Is there a fix for this?
I am also looking for a hex firmware version that I can roll back to.
As you can see from the upside down photos, the bed heated to 65C. Also, the temp of the hot-end is showing as -14. Weird.
Any help appreciated.
TIA,
Scott
- 20210919_121609.jpg (351.55 KiB) Viewed 1165 times
- 20210919_121620.jpg (357.74 KiB) Viewed 1165 times