Filament issue

Post Reply
Kintalind69
Posts: 4
Joined: Sat Jul 25, 2020 5:48 pm

Filament issue

Post by Kintalind69 » Sat Apr 24, 2021 2:33 am

I just got my A30 printer and the filament for my #0 stops feeding or doesnt feed at all constantly. I can see that the wheel is turning to push it through but it feels stuck. If start pushing it super hard it goes again. I tried adjusting the tension with the screw on the side but it doesnt seem to change anything.

Any ideas? This is really frustrating as it makes the printer useless.

Nozzle temp is right at 200C
Filament is geeetech brand PLA
Top
Post Reply

Return to “Geeetech A30 Series”