Cura profile needed for minis (A10M)

[HankY]

Hi,
I have been trying to configure my A10M to print minis, but it has been very difficult since I am new at this.
I get lots of stringing and sometimes my layers aren't closing properly. Can anyone that prints miniatures share their profile so I can have a (better) starting point? JI am really lost.
Thanks.

I use a A10M and my slicing software is Cura 4.8

[Admin]

Hi, I got you two videos which can show you how to adjust the settings in Cura, and how to import the curaprofile, please check the links below:
https://www.youtube.com/watch?v=JPljmHDLmow
https://www.youtube.com/watch?v=N9x9de4 ... st=LL&t=0s

You can also find our curaprofile on our website: https://www.geeetech.com/download.html?download_id=47