Motors comming to a halt. Later, commands in the queue

[Demoleitor]

Hi,

Please I need some help. My printer was working fine recently, after a week or so since the last usage, I tried to print a new piece. This time, the stepmotors started going slower emiting a different sound until they finally stopped. After that, I had to restart the printer but there was no way to make it work.

After some trials, I noticed therer were always 6 or 7 commands waiting whenever I connected. I remember solving this issue in the past, but now this is weird because It comes from a strange issue, seemed electrical, like a fault power usage or something by the previous behaviour.

Has anyone encountered something similar? I don´t know where to start.

Thanks,

[Demoleitor]

Hi,

I managed to use the manual controls to the printer, again same issue happened, the motors were moving at a slower pace more and more, until complete stop eventually happened. I believe then the issue is with the supply? maybe a condenser? something is clearly wrong but Idk what could be.

Please any help would be really welcomed!

Thanks