Honest opinion on GEEETECH A30

[terkobitel2]

So with a shaky hand, I pushed the buy now button and purchased the GEEETECH A30.

I am a little apprehensive with the purchase as I am a little concerned and cannot find any real info on the software that this unit runs. It states that it is a propitiatory software.

Being new to 3D printing, and having a Creality Ender 3 pro, is there many differences that I can expect on printing in CURA, as it is the only program I am familiar with.



Thank you for your in put.

Cheers

[lion]

If you are worried that a30 does not support cura, you don’t need it. You can use it on cura easily.
The parameter setting can refer to the manual, very smart.