I got my very first 3D printer and wanted to test it by printing the benchy. So I added the printer in cura via custom fff printer, entered the dimensions, filament size, heated bed etc. After putting in filament and leveling the bed I started the print and the printer started, but the nozzle wasn't nearly where I leveled it, but rather 2-3 mm above the plate. Obviously i canceled the print.
Did anyone have the same problem or know where this may come from? Could false settings in cura be the cause or did I fail at leveling the bed correctly? Or is it something I totally missed?
I researched on the internet and I saw you can set an z offset value in your starting gcode. Should I just try to find a value to lower the nozzle?
Thanks for your help!
https://omegle.onl/ vshare
Problem with Geeetech A30: Z Axis is 2-3mm above the bed at the start of the print
-
makerbiles6
- Posts: 3
- Joined: Mon Jul 13, 2020 9:21 pm
Problem with Geeetech A30: Z Axis is 2-3mm above the bed at the start of the print
Last edited by makerbiles6 on Tue Jul 14, 2020 2:37 pm, edited 1 time in total.
Re: Problem with Geeetech A30: Z Axis is 2-3mm above the bed at the start of the print
Hi, if you are not using 3Dtouch, it is recommended to re-level, you can adjust the height of the hot bed by the knob under the hot bed.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!