Prusa i3 pro B print quality issues

[harrynice]

Hi all,

I am having loads of trouble trying to get my printer to calibrate and print properly, resulting in the prints you see in the attached picture (yellow was supposed to be a calibration cube, white was a simple disk).



Is anyone able to give an initial diagnosis of what I need to do based on what they can see? I appreciate that this is a broad remit, but am hoping someone can point me in the right direction.

Thanks in advance!

[William]

Hi,you can check whether the step vanule corresponds to the value in the picture below.

TIM图片20200416153537.jpg (33.48 KiB) Viewed 26365 times

[harrynice]

Thanks - someone on reddit gave the same advice and it worked.

Could the firmware not be updated to correct this?

[harrynice]

<duplicate post>

[BlueCross]

Hi all,

I am having loads of trouble trying to get my printer to calibrate and print properly, resulting in the prints you see in the attached picture (yellow was supposed to be a calibration cube, white was a simple disk).



Is anyone able to give an initial diagnosis of what I need to do based on what they can see? I appreciate that this is a broad remit, but am hoping someone can point me in the right direction.
Thanks in advance!
My Pasco Connect

I faced similar kind of issue last time, I am still searching for some proper solution Same issue still no fix to this.
Did you have a fix on this issue? I have the same problem with Facing same issue but no response from anyone and couldnt find this topic troubleshooting in google.

[BlueCross]

Hi all,

I am having loads of trouble trying to get my printer to calibrate and print properly, resulting in the prints you see in the attached picture (yellow was supposed to be a calibration cube, white was a simple disk).



Is anyone able to give an initial diagnosis of what I need to do based on what they can see? I appreciate that this is a broad remit, but am hoping someone can point me in the right direction.

Thanks in advance!

I faced similar kind of issue last time, I am still searching for some proper solution Same issue still no fix to this.
Did you have a fix on this issue? I have the same problem with Facing same issue but no response from anyone and couldnt find this topic troubleshooting in google.