Hey Folks,
i can see the PID values in the Smartto tool. But is there a possibility to do the PID Autotuning. I tried it with the M303 command, but that doesn`t work. And just changing the values is a bit too difficult to me due the fact I don't really know what kind of changes I should do. I need this because I have a new hotend and I have troubles with a stable temperature...
Thanks for your help!
PID Tuning A30
Re: PID Tuning A30
Hi，the M303 interface may need to be optimized.
You can try it by averaging.
You can try it by averaging.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-
EarthwormJack
- Posts: 4
- Joined: Mon Apr 13, 2020 6:07 am
Re: PID Tuning A30
Hey William,
thanks for the answer, but I'm a bit confused now. In my case M303 does nothing. It didn't start any autotuning... That is my problem... Does the firmware normally react on that code?
thanks for the answer, but I'm a bit confused now. In my case M303 does nothing. It didn't start any autotuning... That is my problem... Does the firmware normally react on that code?