Hello everyone,
I do have a problem with my MeCreator 2, the error MAXTEMP BED is showing on the LCD screen. I already have disconnected the heatedbed sensor but the error is still there. The temp of the bed is 164°C and never go down. I did also reflashed the firmaware but the error is still showing.
Can someone help me ?
Error MAXTEMP BED
Re: Error MAXTEMP BED
Hi, If you unplug the hot-bed wire from the motherboard,
If the temperature still shows high temperature,
May be a problem with the motherboard.
If the temperature still shows high temperature,
May be a problem with the motherboard.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Error MAXTEMP BED
Ok thanks for the reply. It does mean that my motherboard is bad then.