Fast filament unload GCode
Fast filament unload GCode
!
Last edited by Maccron on Sun Feb 07, 2021 4:42 am, edited 1 time in total.
A30M with 3DTouch.
Re: Fast filament unload GCode
Hi, Note about using tf card for printing:
The printer can only recognize .Gcode files, and the file name must be English letters, spaces, underscores and combinations thereof;
Gcode files cannot be placed in any folder of the TF card, otherwise the corresponding files cannot be read.
The printer can only recognize .Gcode files, and the file name must be English letters, spaces, underscores and combinations thereof;
Gcode files cannot be placed in any folder of the TF card, otherwise the corresponding files cannot be read.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Fast filament unload GCode
!
Last edited by Maccron on Sun Feb 07, 2021 4:42 am, edited 1 time in total.
A30M with 3DTouch.
Re: Fast filament unload GCode
!
Last edited by Maccron on Sun Feb 07, 2021 4:42 am, edited 1 time in total.
A30M with 3DTouch.
Re: Fast filament unload GCode
Hi, Don't save gcode files in folders,After slicing the model through the slicing software,
Save the sliced file to the SD card.
I hope this can help you.
-Keep your mind and try to test it.
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!