Repetier-Host setting on ABS print

[Jarda3d]

Same as PLA except temperatures.

Hotend first 258, then 250 for green, yellow, white, or 245 for gray, red, blue, black
Hotbed first 110 (120 if you can), then 110

[_kaktus_]

Hello Jhonmicky.


You must be guided by the data provided by the manufacturer of the Filament you are using.

Basically I print at temperatures:

• heated bed 90°C
• hot end 240°C

To improve adhesion to the substrate I use Dimafix spray.


My printer has no shield or heat casing.