Print Not Sticking To Bed
-
Chad Harvey
- Posts: 1
- Joined: Sun Oct 27, 2019 7:11 pm
Print Not Sticking To Bed
The print is not sticking to the bed. New A20M, set setting following the manu forum. The bed is leveled accordingly. As it extrudes sometimes the filament sticks to the bed, sometimes not causing. Anyone got recommendations on how to fix. What are best starting setting for speed, heat of bed, nozzle, etc?
Re: Print Not Sticking To Bed
Hi, you can try to level the hotbed.
Try increasing the bed temperature of the hotbed by 5-10°.
Try increasing the bed temperature of the hotbed by 5-10°.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Print Not Sticking To Bed
Post a photo what it means that not sticking on the bed...
Superplate begin 103, then 110 (or 110 both if you want to wait 7-10 mins more)
PEI sheet 110 both.
Superplate begin 103, then 110 (or 110 both if you want to wait 7-10 mins more)
PEI sheet 110 both.
A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.