Problem printing fine detail.

Softfoot · Post by **Softfoot** » Thu Oct 17, 2019 3:10 am

I have a I3 Pro C and am running the latest Repetier-Host and Slic3r.

I am trying to print a replacement drive belt clamp https://www.thingiverse.com/thing:1724855 for a friends unit
but while the print quality is fine the teeth that mesh with the belt are missing!!!

Interestingly, the preview generated is also lacking the teeth - so I guess it's no surprise they dont get printed!

What am I missing?? I have tried 2 different designs and Cura doest the same.

I have the layer height set to 0.2 (but 0.1 dos the same!)

Any suggestions very welcome.

A rather desperate Dave

Post by **William** » Thu Oct 17, 2019 9:23 am

Hi, can you provide your printed picture?
If you want to see the preview, you can view it after slicing the STL.

Softfoot · Post by **Softfoot** » Thu Oct 17, 2019 4:05 pm

The slots that hold the belt are smooth - there is no trace of the teeth that are supposed to engage with the belt.

Yes, I can see the preview - as I said in my post, it does not show the teeth either which I suppose why it is not printing.

Dave

Post by **William** » Thu Oct 17, 2019 4:15 pm

Hi, I tried to slice it,
The preview after slicing is like this:

: NNIO1N15I7U6OI`9I7REKF9.png (603.92 KiB) Viewed 6384 times

Softfoot · Post by **Softfoot** » Thu Oct 17, 2019 10:51 pm

Interesting ... thats NOT what I get

What settings are needed to get that - I am pretty well using the defaults.

It seems that you are using RH v2.1.3 and I am on v2.1.6 --- I wonder if that could be the problem ???

Interestingly in desperation I tried EasyPrint3D and that worked a treat! So that has got my friend out of the manure

But I need to use BOTH extruders so I need RH.

Regards,
Dave

Geeetech

Problem printing fine detail.

Problem printing fine detail.

Re: Problem printing fine detail - help needed!

Re: Problem printing fine detail.

Re: Problem printing fine detail.

Re: Problem printing fine detail.