How to discharge the filament of the extruder E1 for A10M

[vap38]

Hello,

For the A10M printer it is easy to unload the filament of the E0 extruder by the keyboard!
But how to unload the E1 extruder film on the Geeetech menu command?
We know the command M701 and M702 to load or unload a simple extruder E0.
how to make the change in MARLIN?
To make it easy I turn the wheel of the E1 extruder by hand (it's not easy)
Thank you for your help.
cordially

[William]

Hi，If you are referring to pushing consumables,
You can try to heat the nozzle to 200° and then manually push the consumables.

[vap38]

thank you for the answer !
I heat the extruder to 200 ° before removing the filament on the extruder E1 without problem but it's not fast and not practical!
can we change the Gcode on MARLIN ??

[William]

good idea， but I'm afraid not.

[N8nNC]

1. Go to mixer screen.
2. Set mix to 100 / 0% to load/unload Extruder 0
or 0 / 100 to load/unload Extruder 1

[N8nNC]

1. Go to mixer screen.
2. Set mix to 100 / 0% to load/unload Extruder 0
or 0 / 100 to load/unload Extruder 1

[vap38]

Hello,
I tried the trick of super filament change that works
thanks for the good idea.
how to activate the cleaning of the hot head in the basin in Malin?
So it would be very simple to use the control panel of Geetech A10M

[Jarda3d]

Nozzle cleaning is at the start of each print with my gcode profiles.

[lainabrookie]

for geeetech members

[dominic84579]

This works really well for us,MyLowesLife thank you! Facing same issue here. Help is appreciated.