Change the software

[chuotbay1]

Hi all,
Perhaps I can still use my GT2560 Board and only change the software ??
Target should be, to ba able mixing colors etc like the M201 software allows it!
I've not many experiences in flashing softwares, dont want to break something. The Prusa I3 is printing very well so far. Just want to make it better
Thanks

[William]

Hi, Do you mean using an extruder that is similar to two in and one out?
you can refer to this:http://www.geeetech.com/forum/viewtopic ... 13&t=17517