UBL mesh probing on the edge of the bed

wotor · Post by **wotor** » Mon Aug 12, 2019 5:17 am

Hi. I will put my post in geeetech board
can someone tell me how to change UBL mesh size? i got little accident with my A10M . i uploaded Vert's build 378 and now when i try to create UBL mesh, BLTouch is probing on very edge of my bed (same thing with Level Corners) and on clips holding glass to hotbed(i don`t have glued bed). previously i was using Vert's build 271 and everything was ok.

wotor · Post by **wotor** » Mon Aug 12, 2019 7:38 am

Ok EOT. I found it.

Post by **William** » Mon Aug 12, 2019 9:37 am

Geeetech

UBL mesh probing on the edge of the bed

UBL mesh probing on the edge of the bed

Re: UBL mesh probing on the edge of the bed

Re: UBL mesh probing on the edge of the bed