MK8 Dual Extruder mod

Spader126 · Post by **Spader126** » Tue May 07, 2019 10:59 am

Has anyone had any luck in Modding the A20M mix color to a true Dual Extruder using the MK8?

I am wanting to do this as I like the print size of the A20M but i would like to use one extruder for PLA or ABS, and the other for support material (PVA or HIPS)

Any helo would be greatly appreciated on if this is even possible, and if/or how to go about doing it.

rdhoggattjr · Post by **rdhoggattjr** » Wed May 08, 2019 9:18 pm

I plan on trying to do this and have some of the parts ordered. From searching I have found that they use to have or will have an A10D. I'm trying to find the extension board for it.

rdhoggattjr · Post by **rdhoggattjr** » Wed May 08, 2019 10:57 pm

vert wrote: ↑
Wed May 08, 2019 10:52 pm

as far as i know they stop production on the A10D.

Thank you for letting me know.

Then I will come up with other means and post them here.

Geeetech

MK8 Dual Extruder mod

MK8 Dual Extruder mod

Re: MK8 Dual Extruder mod

Re: MK8 Dual Extruder mod