Hi,
I'm trying to connect a PT100 thermistor with amplifier. I managed to find a 5V and GND pins on the board, but don;t know where are the analog pins, or which numbers they would be.
Can anyone help?
Analog pins on GT2560 V3 (A20M printer)
Re: Analog pins on GT2560 V3 (A20M printer)
Hello.
The diagram available for this controller board does not correspond to the physical realization.
The board has a dedicated connector.
.
Here you have a description of the leads.
.
To check which pin corresponds to which µC lead, use a multimeter.
Unfortunately I don't have this controller board.
However, if you would like to present the results of your research here, it would be great.
The diagram available for this controller board does not correspond to the physical realization.
The board has a dedicated connector.
- GT2560_v3_ADC.jpg (351.08 KiB) Viewed 4795 times
Here you have a description of the leads.
- pinout-ATMega2560_ADC.png (125.95 KiB) Viewed 4795 times
To check which pin corresponds to which µC lead, use a multimeter.
Unfortunately I don't have this controller board.
However, if you would like to present the results of your research here, it would be great.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.