Use the plastic mounting spacers for the controller board and the LCD module.
I expect the mass potential (GND) to penetrate the frame of your printer.
Diagnostics for GT2560!!
Re: Diagnostics for GT2560!!
Hello.
Use the plastic mounting spacers for the controller board and the LCD module.
I expect the mass potential (GND) to penetrate the frame of your printer.
Use the plastic mounting spacers for the controller board and the LCD module.
I expect the mass potential (GND) to penetrate the frame of your printer.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: Diagnostics for GT2560!!
I think your printer PSU have an issue or your printer have a short circuit.
You can try to re-burn the bootloader for it at first.
You can try to re-burn the bootloader for it at first.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!