- 20181227_013310.jpg (368.95 KiB) Viewed 3508 times
- 20181227_013613.jpg (328.57 KiB) Viewed 3508 times
X Axis Wheels Sliding Out
X Axis Wheels Sliding Out
On the A10 M series printer, the upper wheels that allow the extruder to move along the x axis seem very easy to slip out of their track, even with just a light touch. This usually results in them not hitting the appropriate endstop. So, the motor grinds when I try to home the device. It pretty much has full mobility, but the leftmost wheel slips out of the track right before the endstop or right after. If anyone has any suggestions, I'd really appreciate it
Re: X Axis Wheels Sliding Out
Figured it out! I tightened a nut on the underside of the carriage by the bottom wheel, resulting in a more secure grip. Just had to use one of the provided wrenches, must simpler than I had feared.
Re: X Axis Wheels Sliding Out
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.