3D touch/Pro W won't home

[Kiamiya]

Hello,
After weeks of search without any clue, I come here to ask for some help.

Here a link to the video of my issue (I made an emergency stop at the end)
https://youtu.be/1MyBdcKjtmc

I use this firmware

firmware.JPG (21.86 KiB) Viewed 17672 times

Also here my wiring

cable bn.JPG (255.55 KiB) Viewed 17672 times

cable rom.JPG (266.09 KiB) Viewed 17672 times

So, all is good with the selftest but, when I try to Home, the pin goes up and never do it's job..

Any clue for me?
Thanks

[TwiHul]

I never managed to get it working with Marlin 1. I used Marlin 2 and managed to figure it out from there. There’s an example config out there that uses the Z MAX pins instead of Z MIN but I had to change it to just use Z MIN to get it working.