kaktus' guide - fans - however, it was not the end

[_kaktus_]

Because I am very irritated by the noise of a small hotend fan, I decided to get rid of the noise.
Each time the printer is turned on, this toddler operates at full power. It makes a horrible noise. No matter if it is needed or not.

That's why I do not like him very much. But it's not his fault ;-D

I was so mad at him that I invented a quick effective solution.
I dealt with him using one additional connection.
yes, no joke. By adding one wire I got individual control for this small fan. ;-D

Having knowledge from previous kaktus' guides it was not difficult to do.

I unplugged the cable located near the head cart.
An additional cable connected the fan to the EXT2 socket, pin 6
Of course, we're talking about a fan cable with a GND signal.
[attachment=0]przepis_na_wnetylator.jpg[/attachment]

Using this way I got full control of the fan control from the program used by me.
The solution is fabulously simple and effective. It is therefore recommendable.
That's why I present them.

Video with the presentation: https://www.youtube.com/watch?v=PPMQvdSp644
it's worth listening carefully ;-D

[Tomyuan]

I have watched the video of yours. That's so cool!

[_kaktus_]

Hello wholeheartedly to all users of the M201 model.



The next description was created in the topic about fans of our printer.
Everything indicates that this one will be the last one, directly related to fans.

A link to the description.