No Filament transport with MK8 Extruder

Post Reply
BR365
Posts: 57
Joined: Mon Apr 16, 2018 7:24 pm

No Filament transport with MK8 Extruder

Post by BR365 » Mon Apr 16, 2018 7:27 pm

Hello,
we assembled the Geeetech I3 Pro C Dual sucessfully, but the filament transport seems to not working. When printing from the PC software, there is only one little drop of filament on the nozzle.

Is it neccesary to set up the E-Steps for the filament transport?

Regards,
Moritz
Top
BR365
Posts: 57
Joined: Mon Apr 16, 2018 7:24 pm

Re: No Filament transport with MK8 Extruder

Post by BR365 » Wed Apr 18, 2018 2:07 pm

I found the problem: The connector for the stepper motor of Extruder 1 and 2 were interchanged. Now, it works fine.
Top
Post Reply

Return to “Geeetech I3 Pro C”