Level bed sensor on pro b need help

[halleuxgeoffrey@msn.com]

hello, I installed correctly the sensor but the tilt tends to hang and activated the alarm (red flashing)
It hangs down, I try to go up or down the screw (magnet), it works but from time to time it still blocks, do you have any tips or a link to correctly configure the sensor screw please ?
thank you

[William]

I think you should refer to your 3dtouch user manual at first?

[halleuxgeoffrey@msn.com]

Nothing about this adjustement with the magnet screw on top of the sensor anywhere.
With chance, it happen not too much, but when arrive, i must enter the gcode for stop the alarm and adjust the screw, is it like the screw move itself when extrudor viber.