Z-Axis Problem, Couplings run irregular

[Friedl792]

Hello,

I assembled my Prusa i 3 pro W yesterday and the z-Axis won't move properly in the lower section. I took of the threaded rods and let only the motors spin. You can see in this video, that the couplings are not running smoothly.

https://www.youtube.com/watch?v=ZAB0yCwdXXA

https://www.youtube.com/watch?v=UuYjFVqSOxI

In the second video i put on the threaded rods again. In the upper part the motors can move but you can see it is very irregular. The Rods are straight. Do I need new couplings or can I fix this somehow?

Friedrich

[William]

I think you should mount the couplings as I show you. The shaft of the motor should go into the hole of coupling more length.

coupling.jpg (57.08 KiB) Viewed 5332 times