When I auto home the x and y axis go to where there supposed to go but the z axis goes the compleatly wrong direction, when I'd hold the z stopper down ut only stops the motor moving up not down.
I'm not sure if it's a software issue or electrical but I can't find anything helpful online.
The home setting for the z axis goes the wrong way on my aluminum prusa i3
Re: The home setting for the z axis goes the wrong way on my aluminum prusa i3
Please check if the Z end stop is OK. And you can use the command M119 to get the status of end-stop.Ddman114 wrote: ↑Mon Aug 28, 2017 4:28 amWhen I auto home the x and y axis go to where there supposed to go but the z axis goes the compleatly wrong direction, when I'd hold the z stopper down ut only stops the motor moving up not down.
I'm not sure if it's a software issue or electrical but I can't find anything helpful online.
If the end-stop connection of Z axis is OK, and you have to change the direction of Z axis in configuration.h file.
A post you can refer to: http://www.geeetech.com/forum/viewtopic ... 17&t=17037
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!