I3 Pro C

[Xaroos]

Hi
I am assembling my I3 Pro ,in the wiring section it says connect X motor to here Y motor to there but no where it says which one X motor or Y motor,
The instruction that comes with it shows a video for assembling a similar printer but not exact like there is no mention of the fan that goes behind the print head I saw that in the picture on Ebay!
The whole instruction does not talk about using washers for screws but it comes with 105 washers!
There is no Mention of END STOP TRIGGER assembley which is hard to do after putting the head on.
I would like to have a picture of wire management too specially for the pars that are moving.
Thanks

[Newopint95]

what I3 Pro do you have?
The Y axis motor drives the bed.
The X axis motor drives the print head.

I can post some pictures of the cables on my I3 Pro B tomorrow.

[William]

what I3 Pro do you have?
The Y axis motor drives the bed.
The X axis motor drives the print head.

I can post some pictures of the cables on my I3 Pro B tomorrow.

I3 pro c ,titled in the top of the post.

[William]

Could you attach a picture or a video about your assembling problems?

[Xaroos]

After going through the whole manual found all the wires but it would have been good to have a sketch of what goes where that the users dont have to waste so much time.