MeCreator 2 Issue

Viniciusrn · Post by **Viniciusrn** » Wed Apr 26, 2017 1:11 am

I bought the printer and I have an annoying problem.

The panel is crazy, as if the button was being pressed all the time, see the video:

https://www.youtube.com/watch?v=lAveMjLeJZQ

Because of this problem I can not print from SD.

* I have already disassembled and made sure that all cables are properly connected
* Updated the firmware

The seller (Banggood) asked to report the problem in this forum.

can you help me?

Post by **William** » Thu Apr 27, 2017 5:29 pm

Hi,I think you can change the cable between LCD and motherboard.

Viniciusrn · Post by **Viniciusrn** » Fri Apr 28, 2017 6:17 am

Turning ON only the motherboard without the LCD cable I can still hear the clicks of menu.
I believe the problem is on the motherboard.

Post by **William** » Fri Apr 28, 2017 10:26 am

Viniciusrn wrote:Turning ON only the motherboard without the LCD cable I can still hear the clicks of menu.
I believe the problem is on the motherboard.

Hi,I guess the firmware you have upgraded also may have problems.So I need to know which version of firmware do you upgrade and which software are you using to do that,Arudino1.0.1 or Easyprint?
As to the board,could you take a video showing the working of board when power is on and some pictures which have unplugged all connections?

Geeetech

MeCreator 2 Issue

MeCreator 2 Issue

Re: MeCreator 2 Issue

Re: MeCreator 2 Issue

Re: MeCreator 2 Issue