Rostock 301 home sequence after printing

[Armstrong]

My Rostock 301 does print well however when homeing after print, it always try to home X axis first while holding the Y and Z axis motor steady. The homing could never been complete as the X axis could only go half way to the home postion and stuck there.
Manully homing could be completed without problem.

[bang]

Check your End Gcode,it should be "G28" not being "G28 X0 Y0 Z0".

[Armstrong]

Thanks bang, the problem has been solved. As I'm using Repetier, the default home sequence was 'G28 X0 ; home X axis', I have now updated with 'G28 ; home all axes' for all my configuration files.