Geeetech M201 with 3 extruders

[syossi2]

hi

this is the special firmware that geeetech made special for me to active the 3 extruders on the GTM32 RevB
on the lcd the 3th extruder temp dosent show, but its work
i mange to config in my m201 trhee options

1. two mk8 extruder ( base on the new steps)
2. two mk8 extruder ( base on the new steps) with one bowden
3. two bowden with one mk8 ( base on the new steps)

all this thanks to the new firmware that they made for me

but !!!! be aware
lot of valus are need tobe change ( and its very hard , becuse the slowly on the knob on the board )
zstep to 2560
home speed z 16
vmax z 2
ve-jerk 5

and maybe more , i dont remember, and i dont neer the printer to check
but please update about your value and how did it work for you
of curse on your on risks......

M201_3extruders.zip

(63.35 KiB) Downloaded 648 times

thanks
yossi

[TheDirector]

Hi! COuld you post the rest of the values you have set to get this working?