steppers not moving

[BluDK]

Hello

I have just assembled my Geeetech Acrylic Prusa I3 pro B but I cant get my steppers to move also I cant get the extruder to warm up.

I can read the temp for the bed and the extruder.

I have read that it could be a firmware issue can you send me the newest version?

this is the board



Best regards
BluDK

[William]

Hi,
Can the board be connected to your computer and Repetier Host?
1.About the motor not moving,check this:
http://www.geeetech.com/forum/viewtopic ... 17&t=17038
2.Heating issue:
http://www.geeetech.com/forum/viewtopic ... 19&t=17039
3.Check the control board:
http://www.geeetech.com/forum/viewtopic ... 18&t=18061
If all of this can't fix your problem,try uploading the firmware,I've put it in the attachment.
Let me know plz if you find something new.

Marlin-PI3_Pro_B.zip

(299.21 KiB) Downloaded 417 times