HELP REQUIRED

[hooked]

Hi,

I had to replace the computer that was connected to my G2 printer. I have installed Repetier Host on the new computer but can't get the printer working.

Repetier host does connect but I get the following message. "No Start Signal detected - forcing start"

Do I have to reload the printer firmware. I'm assuming it is still resident on the printer EEPROM.

Any suggestions would be greatly appreciated.

THANKS

Daryl

[hooked]

Disregard my post. I found the problem. I had not installed the fdi driver.

Cheers

Daryl

[William]

Disregard my post. I found the problem. I had not installed the fdi driver.

Cheers

Daryl