GT5 issue

[CupaCabra]

I have a GT5 Extruder and my Problem are the filament will not drown by the gear.
I have the ball-bearing Wheel attracted more or less nothing attracted

It Looks like the filament slipping

How i can fix it

[Mark]

maybe this link will help you:
http://www.geeetech.com/forum/viewtopic ... 19&t=17097

[CupaCabra]

hello, the motor power is ok the problem are the filament slips away from the filament gear.
i think the presure are no high enough between the 2 gears or the filament-grear not sharp enough.