Motor axis direction during Auto Home Command

Post Reply
flipdave
Posts: 6
Joined: Sun Nov 15, 2015 5:05 am

Motor axis direction during Auto Home Command

Post by flipdave » Sun Nov 15, 2015 2:55 pm

Which direction should each drive move during the Auto Home command? My Y drive moves the bed aft towards the Y limit switch, the X drive moves the extruter left, away from the X axis limit switch, and the Z drive moves the extruter down towards the bed.
Top
Sherry
Posts: 362
Joined: Wed Jul 01, 2015 12:52 pm

Re: Motor axis direction during Auto Home Command

Post by Sherry » Mon Nov 16, 2015 3:34 pm

flipdave wrote:Which direction should each drive move during the Auto Home command? My Y drive moves the bed aft towards the Y limit switch, the X drive moves the extruter left, away from the X axis limit switch, and the Z drive moves the extruter down towards the bed.


all of axis should go toward their endstops.it seems that your x axis direction are reversed.you can change it's direction in the firmware.
Attachments
QQ图片20151116153019.jpg
QQ图片20151116153019.jpg (63.24 KiB) Viewed 7718 times
Top
flipdave
Posts: 6
Joined: Sun Nov 15, 2015 5:05 am

Re: Motor axis direction during Auto Home Command

Post by flipdave » Tue Nov 17, 2015 2:32 am

Thanks Eric, where do I find that latest file for the Prusa I3 with I think it's the GT 2560 board
Top
flipdave
Posts: 6
Joined: Sun Nov 15, 2015 5:05 am

Re: Motor axis direction during Auto Home Command

Post by flipdave » Tue Nov 17, 2015 3:03 am

Never mind , I found the file!
Thanks
Top
flipdave
Posts: 6
Joined: Sun Nov 15, 2015 5:05 am

Re: Motor axis direction during Auto Home Command

Post by flipdave » Tue Nov 17, 2015 3:59 am

Never mind , I found the file!
Thanks
Top
Post Reply

Return to “Stepper Motor”